Float Level Inspection - Honda XL200 2001 Shop Manual

XL2 0 0
Install a new O-ring into the groove in the carburetor body.
Install the cover and tighten the screws securely.
Install the following:
– Needle jet/needle jet holder/main jet
– Slow jet
– Washer/O-ring/spring/pilot screw
NOTE
• Install the pilot screw and return to its original position as
noted during removal.
Perform pilot screw adjustment if a new pilot screw is installed.
Install the following:
– Float valve
– Float
– Float pin
– Baffle plate

FLOAT LEVEL INSPECTION

With the float valve seated and the float arm just touching the
valve, measure the float level using the float level gauge.
Float level: 14.0 mm (0.55 in)
TOOL:
Float level gauge 07401-0010000BR
NOTE
• The float cannot be adjusted. Replace the float assembly if
the level is out of specification.
SCREWS SPRING
NEEDLE JET/NEEDLE JET HOLDER/
MAIN JET
WASHER/O-RING/SPRING/PILOT SCREW
BAFFLE PLATE
FLOAT VALVE
FUEL SYSTEM
O-RING
SLOW JET
FLOAT
FLOAT PIN
FLOAT LEVEL GAUGE
4 -9