Gearshift Linkage Removal - Honda XL200 2001 Shop Manual

XL2 0 0
Install the oil filter rotor.
Apply oil to the lock nut threads.
Install the lock washer and lock nut.
NOTE
• Install the lock washer with its "OUT SIDE" facing out.
• Install the lock nut with the chamfered side facing, the lock
washer.
Hold primary drive and driven gear with a gear holder, then
tighten the lock nut to the specified torque.
TORQUE: 85 N.m (8.5 kg.m, 61 ft-lb)
Install the oil pump.
Check the oil filter cover gasket is in good condition, replace if
necessary.
Install the gasket onto the oil filter cover.
Install the oil filter rotor cover and tighten the screws securely.
GEARSHIFT LINKAGE
REMOVAL
Remove the oil pump
Remove the clutch (page 8-3).
Remove the bolt and gearshift pedal.
CLUTCH/GEARSHIFT LINKAGE
OIL FILTER ROTOR
OIL FILTER ROTOR LOCK NUT
LOCK NUT WRENCH
GEAR HOLDER
COVER
GEARSHIFT PEDAL
WASHER
EXTENSION BAR
SCREWS
BOLT
8 -9