2.
Remove the Phillips M2.0 × 2.5 screw (2), and then remove the WLAN module (3).
NOTE:
black WLAN antenna cable connects to the WLAN module #1 Aux terminal.
3.
If the WLAN antenna is not connected to the terminal on the WLAN module, a protective sleeve must be
installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
Speakers
To remove the speakers, use this procedure and illustration.
28
Chapter 5 Removal and replacement procedures for authorized service provider parts
The #1 white WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2