Fujitsu SPARC M12-1 Installation Manual page 64

For supporting columns with M6 screw holes
■
Remove the pins at the front and rear of the rail.
a. Remove the pins (A in
b. Store the removed pins (four pins in total) for future use when the PCI
Figure 3-17 Removing a Rail Pin
Loosen the two screws (B in
4.
Note - After loosening the screws, hold the rail level with both hands. If the rail tilts, it may
stretch.
54 Fujitsu SPARC M12-1 Installation Guide ･ June 2021
rails.
expansion unit is moved.
Figure 3-17) at the front and rear of the left and right
A
Figure 3-18) from the side of the rail.