Table of Contents
Advertisement
4.5.3.3 Paper Exit Side Aligner Belt (Green Belt) Replacement
1. Remove only one (the one closest to the frame) of the E-Rings of the J5 latch on
the right end (front door side).
2. Push the J5 latch in toward the front door until it clears the rear frame.
3. Pull the entire J5 Latch, door latch out and set it aside.
4. Remove the Rear Aligner Idler Paper Guide assembly as described in "Aligner
Panel Removal on page 4.6.1.
5. Remove the 4 screws (2 rear and 2 front) of the curved sheet metal Exit Paper
Guide assembly [1].
6. Pull the entire sheet metal Exit Paper Guide assembly out, set aside.
The Aligner is the large sheet metal assembly that contains the Aligner belt (green
belt).
Figure 4.33 Removing Exit Aligner.
78
[1]
Advertisement
Table of Contents
