Table of Contents
Advertisement
7.6 Leveling & Height Adjustment
7.6.1 Height Setting
No height adjustment of the StreamPunch is required, for an installation site with a level floor,
when docking upstream of the SR4050, SR5020, SK5010 or SR5030. If the floor is uneven then it
is recommended to set the level of the StreamPunch using the downstream device as a
reference. The exit guide of the StreamPunch should be set as shown below for the various
finisher types. When installing the StreamPunch upstream of the SK5000, the StreamPunch will
need to be lowered by approximately 5mm. Follow the same adjustment procedure as in Section
6.2 and use the table below for a reference height.
Downstream
Device Input
Finisher
Reference Height X
4mm
SR5000
4mm
SR4050/SR4080
3mm
SR5020
3mm
SR5030/ SR5040
2.5mm
SK5000*
* Height adjustment required
StreamPunch
Output
X
136
Downstream
Device Input
Finisher
Reference Height Y
SK5010
2.5mm
StreamPunch
Output
Y
Advertisement
Table of Contents
