Table of Contents
Advertisement
Section 3
Output Quality Analysis Procedures
3.1 Centering Punched Holes
3.1.1 Die Set Position Cradle Adjustment
The die set position cradle is set in the factory. However, because of the punched hole
spacing on the PB/C4 die sets, there is a minimal amount of paper on each edge of
the punched paper. The die set position cradle may have to be fine adjusted to center
the punched-hole pattern in the paper.
To adjust the hole alignment:
1. Fold a punched sheet of paper in half lengthwise and the punched-holes should be
aligned. If the punched-holes are not aligned, then the die set cradle must be
adjusted to align the punched holes.
Note: The paper path is always constant, if the holes are not centered, you must
adjust the die set cradle.
2. Remove the 9 screws to remove the back cover. See "Removing the Rear Cover"
on Page 4.1.2
Figure 3.1 Check Hole Alignment.
50
Advertisement
Table of Contents
