Punch Module Motor Drive Belt Replacement - Ricoh StreamPunch Pro Technical & Service Manual

4.7.4.1 Punch Module Motor Drive Belt Replacement

Procedure
Replace the belt when it is frayed, missing teeth, or worn out.
To replace the Punch Module drive belts:
1. With the fan removed from the shaft, work the belt [1] off the clutch gear [2].
2. Install a new belt by looping it over the motor pulley and then work it onto the
clutch gear. The belt requires no adjustment. It should have slight deflection when
pressed.
Figure 4.70 Motor Pulley and Belt.
106