Using 1Ch Battery Charger (Optional); Using 4Ch Battery Charger (Optional) - SATO PV4 User Manual

3-2-2 Using 1CH Battery Charger (Optional)

①
Caution

3-2-3 Using 4CH Battery Charger (Optional)

3-2-3-1 Connecting the cables
Warning
Ver. 1.00
④
③
②
- The printer may incur serious damage if you do not use the battery charger
provided by SATO when using a single battery charger.
SATO is not legally liable for any such damages.
- You must use the battery charger power supply provided by SATO to use the
single battery charger. (AC/DC adaptor is not available)
Use only designated AC/DC Adaptor. (12VDC, 3A
1) Connect the power cord ② to the
battery charger ①.
2) Connect the battery charger ① to the
power connector of the cradle ③.
3) Plug the power cord ② into an electrical
outlet.
4) Insert the battery ④ into the cradle ③ a
snapping sound is heard.
1) Connect the power cord to the Adaptor,
and Connect the Adaptor to the power
connector of the quad battery charger.
2) Plug the power cord into a power Outlet.
Input power is 100 ~ 240VAC, 50/60Hz,
1.0A.
3) When the power is applied, the yellow,
green and red LEDs are on for three
seconds and do the self-test.
- 15 -
)
PV4