SATO PV4 User Manual page 16

3-2-3-2 Charging Battery
NOTE
Battery charging status descriptions are as follows.
LED
Red LED On
Green LED Blinking
Green LED On
Red LED Blinking
Warning
Ver. 1.00
Charge Status
Over 80% Charged
Fully Charged
Error Replace
or Reinstall Battery
- If the red lamp of the charger blinks, install the battery again.
- If the red lamp continues to blink after several attempts (4 ~ 5 times)
to install the battery, contact your local dealer.
- The charging time may vary depending on the type of the charger or
ambient temperature.
1) Insert the battery into the 4CH Battery
Charger as shown in the figure on the left.
2) Gently slide the battery until it reaches the
bottom of the charger.
3) Charging starts as soon as the battery is
completely inserted.
4) After charging, remove the battery from the
4CH Battery Charger.
Charging
- 16 -
PV4
Charge Time
Within 10 hours