Setting Up The Logo; Saving The Setup - Barco ScreenPRO-II User Manual

5. System Setup
pÉííáåÖ=ìé=íÜÉ=ildl
With ScreenPRO-II, you can set the LOGO source as a captured still frame, or leave it as
Black (the default value upon factory reset). You can also change which source you use
during the course of a live production.
Use the following steps to set up the LOGO source:
1.
2.
3.
4.
5.
Please continue with the "
p~îáåÖ=íÜÉ=pÉíìé
When all system setup procedures have been completed:
1.
2.
Once pressed, the Touch Screen menu reads " Saving System Configuration ." This step
ensures that when you cycle power, the ScreenPRO-II returns to the state in which it was
configured at the time of the "save."
ScreenPRO-II • User's Guide
Ensure that your background input(s) are properly set up as DVI sources. These
background inputs (along with scaled images from layers A and B) are the
sources of still frames which you can capture. Refer to the "
a Background or DSK " section on page 109 for setup details.
In Chapter 6, refer to the "
instructions on capturing still frames. Up to three frames can be captured: FG_1,
FG_2 and FG_3.
Ensure that the LOGO is cleared from Program. You cannot set up the LOGO
while it is on Program.
In the Layer Control Section , press the LOGO button. The button will blink and
the LOGO Input Setup Menu will appear.
On the Type line, select the desired still frame, or select Black .
Note Because the LOGO is the highest priority layer and
downstream of all other effects, the "black" source can serve
as a convenient way to fade all effects to black.

Saving the Setup

From the Home Menu press { SYSTEM } to display the System Menu .
Press { SAVE } to save all settings in the system file.
Capturing Still Frames " section on page 137 for
" section on page 113.

Setting up the LOGO

Using a DVI Input as
113