Troubleshooting Ethernet Communications - Barco ScreenPRO-II User Manual

`K==réÖê~ÇáåÖ=pçÑíï~êÉ
Ethernet Upgrade Method
23. Click Communication > Ethernet > Connect to display the Ethernet
Figure C-9. Ethernet Connection Dialog (sample)
24. In the dialog, enter the IP address of the ScreenPRO-II: 192.168.0.10 . The
25. Click the Connect button. If the connection is successfully established, the
26. To upload files to the ScreenPRO-II unit, click the " Open script file to read and
27. In the dialog, select " Upload_All.sld " and click Open . The flash loader echoes
28. It takes approximately three minutes to load the flash memory using the Ethernet
29. Cycle power on the ScreenPRO-II unit, and exit the Flash Loader utility.
30. On ScreenPRO-II, perform a factory reset:
31. On ScreenPRO-II, verify that the new software has been loaded correctly:
164
Connection dialog.
Note If the Ethernet menu pick is grayed out, set the COM port to
None .
default port number is 3000 .
message " Connect via Ethernet successful " will be shown in the Status Bar. If
you cannot connect, refer to the "
section on page 165 for instructions.
upload " button.
commands while the flash is being loaded.
method. When complete, the Flash Loader utility displays the " Upload
Complete " message. Click OK to continue.
Warning Use caution when performing this step, as all saved files and
saved still frames will be erased.
From the Home Menu , press { SYSTEM } to access the System Menu .
a.
b. From the System Menu , press { RESET } to display the Reset Menu .
c. On the Reset Type line, select FACTORY .
d. Press { RESET }. When the confirmation screen appears, press { YES } to
reset the system to factory default values.
From the Home Menu , press { SYSTEM } to access the System Menu .
a.
b. From the System Menu , press { SW VER } to display the Software
Version Menu , then verify the new version.

Troubleshooting Ethernet Communications

ScreenPRO-II • User's Guide
"