Working With Pips In Split Mode - Barco ScreenPRO-II User Manual

6. Operations
Working with Layers
tçêâáåÖ=ïáíÜ=hÉóë=áå=péäáí=jçÇÉ
In Split Mode , the mixer's two layers operate independently .
Use the following steps to work with Keys in Split Mode .
1.
2.
3.
4.
5.
6.
7.
8.
tçêâáåÖ=ïáíÜ=hÉóë=áå=jáñ=jçÇÉ
In Mix Mode , the mixer's layers are ganged together. Both Keys can be perfectly co-
located on screen ( Mix Source mode), or both can operate independently ( Swap mode),
but only one Key can be on screen at a time.
Use the following steps to work with Keys in Mix Mode .
1.
2.
126
Note Even though this mode allows you to display two PIPs (or
Keys) on air, it is more restrictive. Once both layers are on
Program, you must transition them off Program, make
changes — and then transition them back on.
In the Mixer Functions Section , ensure that the Split Layer button is On .
Press the desired layer button ( A or B ). Please note:
~
The layer button blinks to indicate that it is active for modification.
~
In the Source Selection Bus , the source currently assigned to the layer
blinks.
~
On the Preview monitor, the raster box for the selected layer blinks (even
if it is hidden under another layer).
In the Mixer Functions Section , ensure that the KEY button is lit and the Key
Menu is visible. If the menu is not visible, press KEY .
Note Even if the layer is on Program, the Key Menu appears, but
parameters can not be adjusted.
On the Source Selection Bus , press the button for the desired (new) key source.
The button blinks to indicate that it is selected, and the source appears on
Preview.
Adjust the Key's mode, clip, gain, opacity, fill source, size, position, source image
and cropping as desired. Refer to the "
details.
Prior to the transition, an additional PIP or key can be set up if desired in Split
Mode :
~
To set up an additional " Split Mode " Key in Preview, repeat the
procedure from step 2.
~
To set up a PIP in Preview, refer to the "
Mode " section on page 123.
Transition the "look" to program with a WIPE , CUT or MIX . Refer to the "
with Transitions " section on page 135 for details.
Repeat the procedure from step 1 for the next transition.
In the Mixer Functions Section , ensure that the Split Layer button is Off .
Press the desired layer button ( A or B ). Please note:
Modifying Keys " section on page 127 for
Working with PIPs in Split
ScreenPRO-II • User's Guide
Working