Quick Input Setup Procedure - Barco ScreenPRO-II User Manual

5. System Setup
3.
4.
5.
6.
Please continue with the "
nìáÅâ=fåéìí=pÉíìé=mêçÅÉÇìêÉ
This procedure enables you to quickly acquire and save inputs. Please note the following
important prerequisites:
•
•
•
Use the following steps to perform a quick input setup:
1.
2.
ScreenPRO-II • User's Guide
f. Press { BACK } to return to the Output Menu .
Press { SETTINGS } to display the Settings Menu .
a. Scroll to the Output Monitor line and select the monitor(s) that you want
to be affected by the sync settings.
b. Scroll to the Sync Out line and set the desired sync value.
c. Scroll to the SOG line and enable or disable the "sync on green" signal
as required.
d. Scroll to the Gamma line and set the output gamma to match that of your
projector.
e. Press { BACK } to return to the Output Menu .
Press { GLCK } to display the Genlock Menu .
a. Scroll to the Source line and set the genlock source, either Black Burst ,
CSync or None .
b. Press { BACK } to return to the Output Menu .
Press { SAVE } to save all output settings in the output file.
At the projector itself, perform additional setup procedures (e.g., color balance,
alignment, etc.) as required. When all procedures are complete, you can turn the
test pattern off using the Test Pattern Menu .

Quick Input Setup Procedure

Ensure that you have completed your input connection chart. In Chapter 3, refer
to the " Input Connection Chart
Ensure that all inputs are properly connected to the chassis.
Ensure that the system has been "factory" reset. Refer to the "
Default " section on page 101 for details.
On the Source Selection Bus , press an input button. The system will
automatically perform a "force acquire" on the selected input, and the Input
Acquisition Menu will be displayed.
If the acquisition was successful, the image will appear full screen on Preview.
~
If you are happy with the image's appearance, press { SAVE }. The Input
Menu will appear for that specific source.
~
If an error message appears on the Input Acquisition Menu , check all
cable connections. You can then:
• Press { FORCE ACQUIRE } to re-attempt acquisition, or ...
• Press { ADJUST } to display the Input Menu without performing
a FORCE ACQUIRE.
To fine tune the input using the Input Menu , refer to the
" Comprehensive Input Setup
Quick Input Setup Procedure
" section on page 103.
" section on page 30 for details and instructions.
" section on page 104 for details.
Return to Factory
103