Barco ScreenPRO-II User Manual page 181

fåíÉêå~ä=oçìíÉê=`çåÑáÖìê~íáçå
The figure below illustrates the connections required for the following configuration:
•
•
Internal Routing
Analog Inputs 1-8
HD/SD Inputs 1-2
(HD Model Only)
Analog Inputs 1-8
HD/SD Inputs 1-2
(HD Model Only)
Figure D-1. ScreenPRO-II Units using Internal Source Routing
Use the following steps to connect ScreenPRO-II units as remote destinations, each
using internal source routing:
1.
2.
3.
4.
5.
ScreenPRO-II • User's Guide
Two (or more) ScreenPRO-II units are used as unique destinations.
Internal source routing is used on each ScreenPRO-II.
ScreenPRO-II
Using a standard Ethernet cable, connect the Ethernet Port on the rear of the
ScreenPRO-II chassis to your system's Ethernet Hub (or Switch ). In Chapter 2,
refer to the " ScreenPRO-II Rear Panel
Ethernet port.
Note A completely "local" network is strongly recommended,
without IP connections to the outside world.
Repeat step 1 as required for each ScreenPRO-II chassis that you wish to use as
a destination.
Using a standard Ethernet cable, connect the Ethernet Port on the rear of the
Encore (or ScreenPRO-II) controller to the Hub . Refer to the " Encore User's
Guide " for the location of the controller's Ethernet port.
Connect your analog and digital sources to each ScreenPRO-II in the normal
manner. In Chapter 3, remember to complete the "
page 30 to streamline your source installation procedure.
Please continue with the " Setting Unique ScreenPRO-II IDs
page 176.
aK==oÉãçíÉ=`çåíêçä
Using Remote Control
Encore Controller (SC or LC)
Ethernet
Hub / Switch
" section on page 12 for the location of the
Input Connection Chart " on
" section on
169