Setting Up The Dsk; Using A Dvi Input As The Dsk; Using A Still Frame As The Dsk - Barco ScreenPRO-II User Manual

5. System Setup
pÉííáåÖ=ìé=íÜÉ=aph
With ScreenPRO-II, you can use a DVI input or a still frame as the DSK source. You can
also change which source you use for the DSK during the course of a live production —
provided that the DSK has been properly set up.
The following topics are discussed in this section:
•
•
rëáåÖ=~=asf=fåéìí=~ë=íÜÉ=aph
This procedure enables you to set up a DVI source as the DSK's input "type." It is
recommended that you perform these steps as a setup procedure. However, once the
DSK is set up, during live production you can easily switch it between a captured still frame
and a DVI source — provided that you change the DSK "type" on Preview.
Use the following steps to set up a DVI input as your DSK source:
1.
2.
3.
Please continue with the "
ScreenPRO-II • User's Guide
Note Remember that the B DVI input is shared between
Background B and the DSK , and the on-air usage is
mutually exclusive — both cannot be on-air simultaneously.
Similarly, you cannot setup the DSK if the B DVI input is
currently in use on-air.

Using a DVI Input as the DSK

Using a Still Frame as the DSK

Ensure that the ScreenPRO-II EDID is properly programmed. Refer to the
" Programming EDID " section on page 107 for instructions.
Ensure that the DSK and Background B sources are cleared from Program. You
cannot set up the DSK while one of the two shared resources is on Program.
If you have not already set up the BG/DSK B input as a DVI source, follow the
setup procedure as outlined in the "
section on page 109.
Using a Still Frame as the DSK
Using a DVI Input as a Background or DSK
" section on page 112.

Setting up the DSK

"
111