2. Push and hold the orange release tab to the left (to the right for the bottom power supply) and grasp the power supply by
its handle. Remove the power supply by pulling it from the node.
Figure 11. Removing a power supply
Install a power supply
About this task
The power supplies are installed in the top and bottom nodes, meaning that the top power supply is installed upside-down. This
procedure works for installing either power supply.
Steps
1. Align the power supply with the slot in the node. The power cable retention bail will be on the right for the bottom power
supply and on the left for the top power supply.
2. Push the power supply into the node until it clicks into place.
Figure 12. Installing a power supply
3. Connect the power cable to the power supply and secure the cord with the retention bail at the connector.
0
1
2
3
1
Base enclosure service procedures
17