Table of Contents
Advertisement
2. Push and hold the orange release tab to the left (to the right for the bottom power supply) and grasp the power supply by
its handle. Remove the power supply by pulling it from the SP assembly.
Figure 33. Removing a power supply
Install a power supply
About this task
The power supplies are installed in the top and bottom SP assemblys, meaning that the top power supply is installed upside-
down. This procedure works for installing either power supply.
Steps
1. Align the power supply with the slot in the SP assembly. The power cable retention bail will be on the right for the bottom
power supply and on the left for the top power supply.
2. Push the power supply into the SP assembly until it clicks into place.
Figure 34. Installing a power supply
3. Connect the power cable to the power supply and secure the cord with the retention bail at the connector.
0
1
2
3
1
Service Procedures
39
Advertisement
Table of Contents
