Install The Internal M.2 Boot Module; Install The Top Cover On The Node - Dell PowerStore 500T Installation And Service Manual

Install the internal M.2 boot module

Steps
1. Touching only the outside edges of the internal M.2 boot module, place the internal M.2 boot module into the slot on the
motherboard.
NOTE: The side of the internal M.2 boot module with the barcodes should be facing up.
Figure 59. Placing the internal M.2 boot module
2. Connect the blue pull tab to the blue connector on the motherboard.
Figure 60. Connecting the internal M.2 boot module to the motherboard

Install the top cover on the node

Steps
1. Position the top cover over the node and align it with the slots in the sides at the rear of the node.
2. Pull the top cover forward to secure it in place.
Base enclosure service procedures 49