Genie Z-51/30J Service And Repair Manual page 89

October 2020
DTC = Diagnostic Trouble Code
FMI = Failure Mode Identifier
SPN = Suspect Parameter Number
1165 5571 15 Rail fuel pressure relief valve
is forced to open. Warning
conditions.
1166 5571 0 Open rail fuel pressure relief valve
was detected.
1167 5571 2 Unexpected opening of the rail fuel
pressure relief valve.
1168 5571 2 Successful rail fuel pressure relief
valve opening cannot be ensured.
1169 5571 13 Averaged rail fuel pressure after
valve opening is outside the
expected tolerance range.
DTC SPN FMI Description
1170 5571 16 Open time of rail fuel pressure relief
valve for wear out monitoring had
exceeded.
1171 94 1 Fuel pressure build up during engine
start not successful.
1172 1347 5 Electrical fuel pump current below
normal or open circuit.
1174 1347 3 Electrical fuel pump voltage above
normal or shorted to high.
1175 1347 4 Electrical fuel pump voltage below
normal or shorted to low.
119 1231 14 CAN Bus 2 off Error for Application
CAN.
1190 7103 13 Rail fuel pressure below set
point, speed-dependent threshold
exceeded.
1191 7103 13 Rail fuel pressure metering unit. Fuel
quantity balance is disrupted.
1194 7103 13 Negative rail fuel pressure governor
deviation at zero delivery by
metering unit.
Part No. 1268553GT
Deutz TD 2.2 L3 Engine Fault Codes
Z®-51/31J
1195 7103 1 Rail fuel pressure value is below
minimum rail pressure threshold.
1197 7103 0 M a x i m u m r a i l f u e l p r e s s u r e
exceeded.
1198 7103 2 Set point of fuel metering unit in
overrun mode not plausible.
120 639 14 CAN Bus 1 off Error for Power train
CAN.
1200 5357 14 Shut-off due to undershoot of
minimum rail pressure.
1202 157 0 Maximum rail pressure exceeded in
limp home mode.
1208 157 3 Engine fuel injector metering rail
pressure voltage above normal or
shorted to high.
DTC SPN FMI Description
1209 157 4 Engine fuel injector metering rail
pressure voltage below normal or
shorted to low.
121 520252 2 Wrong checksum in the CAN
message EAT Control.
1212 629 12 ECU. Keep alive error during runtime
at an external device.
1213 629 12 ECU. Keep alive error during
initialization phase at an external
device.
1215 629 12 ECU. Read diagnosis error for non
volatile memory.
1216 629 12 ECU. Write diagnosis error for non
volatile memory.
1218 629 12 ECU. Stack memory threshold
overrun.
1219 629 12 ECU. Observation counter irregular
switch off counter triggered by
engine running.
122 4207 2 TSC1 message checksum fault.
123 4207 2 TSC1 message checksum fault.
1233 5826 15 Emission control system operator
inducement level 1 severity above
normal operational range.
Service and Repair Manual
79