NT8D72 and QPC720 PRI card installation
Contents
Introduction
PRI circuit pack locations
The section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PRI circuit pack locations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cable requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Switch settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Install NT8D72 and QPC720 PRI cards on Large Systems. . . . . . . . . . . . . . . . . . . 152
Remove NT8D72 and QPC720 PRI cards from Large Systems. . . . . . . . . . . . . . . 154
Use Procedure 12 to remove the NT8D72 and QPC720 PRI cards from Large
Systems.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Install an additional network shelf . . . . . . . . . . . . . . . . . . . . . . . . . . . .
This chapter contains information on how to install the 2.0 Mb NT8D72 and
the 1.5 Mb QPC720 PRI cards on all Large Systems.
Information on how to install the dual-port cards NT5D97 and NT5D12 is
contained in this document.
The PRI circuit pack occupies two adjacent slots on a shelf. As many as five
circuit packs can be plugged into an empty Network shelf, along with a Power
Converter circuit pack. Specific locations will depend on available space.
ISDN Primary Rate Interface
Page 129 of 394
Installation and Configuration
129
129
130
149
154
155