Dive Setup - Garmin DESCENT MK2I Owner's Manual

Dive Setup

You can customize the dive settings based on your needs. Not all settings are applicable for all dive modes.
You can also edit the settings before you start a dive.
Hold MENU, and select Dive Setup.
Gases: Sets the gas blends used in the gas dive modes
have up to twelve gases for each gas dive mode.
Conservatism: Sets the level of conservatism for decompression calculations. Higher conservatism provides a
shorter bottom time and a longer ascent time. The Custom option allows you to set a custom gradient
factor.
NOTE: Make sure you understand gradient factors before entering a custom level of conservatism.
Air Integration: Allows you to pair Descent T1 devices and configure the data screens
page 11).
Water Type: Allows you to select the water type.
PO2: Sets the partial pressure of oxygen (PO2) thresholds, in bar, for decompression, warnings, and critical
alerts (Setting PO2 Thresholds, page
Alerts: Allows you to set tone, vibration, or silent alerts for depth and time. You can enable different alerts for
different dive modes.
Apnea Surf. Alert: Allows you to set alerts for apnea surface intervals.
Safety Stop: Allows you to change the safety stop duration.
End Dive Delay: Allows you to set the length of time before the device ends and saves a dive after surfacing.
CCR Setpoints: Allows you to set high and low PO2 setpoints for closed-circuit rebreather (CCR) dives
CCR Setpoints, page 11).
Backlight: Allows you to adjust the backlight settings for dive activities. You can enable the backlight
throughout the dive or only when you are at depth.
Heart Rate: Allows you to enable or disable a heart rate monitor for dives. The Stored Strap Data option allows
you to enable a chest heart rate monitor, such as the HRM-Swim
data with the dive. You can view chest heart rate monitor data in the Garmin Dive app after you complete the
dive.
Double Tap to Scroll: Allows you to double tap the device to scroll through the dive data screens. If you notice
accidental scrolling, you can use the Sensitivity option to adjust the responsiveness.
UP Key: Allows you to enable or disable the UP button during dive activities to prevent inadvertent button
presses.
Silent Diving: Allows you to disable all tones and vibrations for alerts during dive activities.
Deco Lockout: Allows you to disable the decompression lockout feature. This feature prevents single-gas and
multi-gas dives for 24 hours if you violate a decompression ceiling for more than three minutes.
NOTE: You can still disable the decompression lockout feature after violating a decompression ceiling.
Diving
(Setting Up Your Breathing Gases, page
10).
(Air Integration,
™ or HRM-Tri ™ device, that stores heart rate
10). You can
(Setting
9