Installing The Transmitter On Your Tank Regulator - Garmin DESCENT MK2I Owner's Manual

Installing the Transmitter on Your Tank Regulator

Always use the pre-installed flow restrictor when using the transmitter directly attached to your regulator.
Always use the included air spool when connecting the transmitter to a high pressure hose extension
the Transmitter on a High Pressure Hose Extension, page
restrictor or air spool could result in serious injury or death from an air pressurization failure.
Before you install the transmitter on your tank regulator, you should read the transmitter position tips and
choose the port position that provides the best line of sight to the dive computer.
To install the transmitter, you need a
The transmitter connects to a high pressure output port of the first-stage regulator.
1 Confirm the regulator is depressurized and detached from a scuba cylinder.
2 Remove the port plug from the high pressure output port of the first-stage regulator.
3 Confirm the flow restrictor is installed in the transmitter.
4 Screw the transmitter onto the high pressure output port until you feel resistance.
Verify the installed transmitter does not physically interfere with any hoses or other tank assemblies.
5
5 Use a / in. (16 mm) wrench to tighten the transmitter.
8
To prevent damage to the transmitter and possible loss of function, do not overtighten. Do not use the
transmitter housing to tighten or loosen the transmitter.
Do not grip the regulator or the transmitter to move, carry, or adjust the tank.
Diving
WARNING
14). Using the transmitter without either the flow
5
/ in. (16 mm) open-ended wrench.
8
WARNING
NOTICE
(Installing
13