Installing A V400 Virtual Port Extender; Installing A Half-Duplex To Full-Duplex Converter - Extreme Networks ExtremeSwitching 5520 Series Hardware Installation Manual

Installing a V400 Virtual Port Extender

To attach the V300 switch to a redundant power source (HT models only), do the following:
1. Connect the RPS to the included screw terminal connector (use adequate AWG wire for DIN PSUs).
2. Plug the screw terminal connector into the port extender DC input (PSU2 recommended).
3. Connect the:
•
AC power cord to the AC power input socket on the PSU and plug the other end into an AC
power outlet for non-DIN PSUs; or
•
PSU to an AC power source using the instructions included with the PSU for DIN PSUs.
When power is connected, verify that the PWR LED on the switch turns green. If the PWR LED does not
turn green, verify that the power source is powered on and the connection was made properly.
Installing a V400 Virtual Port Extender
You need the following tools and materials to install a V400 Virtual Port Extender:
•
ESD-preventive wrist strap
•
#1 Phillips screwdriver (for clock module) or flat-bladed screwdriver (for all other VIM modules)
Your V400 Virtual Port Extender comes with two mounting brackets and screws for attaching them.
Mount the equipment in a standard equipment rack, in either a front or mid-mount configuration, in the
same way you would mount a switch.
To install a V400 Virtual Port Extender, follow these steps:
1. Attach the mounting brackets to the sides of the port extender using four screws (included) for each
bracket.
2. Align the holes in the brackets with the rack post holes.
3. Secure the port extender to each post with rack-mounting screws (not provided).
4. Connect an AC power cord to the AC power input socket on the port extender and to an AC power
outlet.
5. When power is connected, verify that the SYS LED on the port extender turns green.
If the SYS LED does not turn green, verify that the power source is powered on and the connection
was made properly.

Installing a Half-Duplex to Full-Duplex Converter

The following options are available for installing the Half-Duplex to Full-Duplex Converter:
1. On a shelf that is mounted in an equipment rack. (The shelf can accommodate up to three
converters.)
See Installing Half-Duplex to Full-Duplex Converters in a 3-Slot Modular Shelf
2. On a flat surface.
See Mounting a Half-Duplex to Full-Duplex Converter on a Flat Surface
3. On a wall.
See Mounting a Half-Duplex to Full-Duplex Converter on a Wall
108 ExtremeSwitching 5520 Series Hardware Installation Guide
Installing Expansion Modules
on page 109.
on page 109.
on page 109.