Installing The Virtual Services Platform 4000 On A Table Or Shelf - Extreme Networks ExtremeSwitching Virtual Services Platform 4850GTS Series Installation Manual

Note:
Cable trays can be provided as an option.
Note:
Power cords must be ordered separately. Ensure you order the correct power code for your
region. For more information, see
Installing the Virtual Services Platform 4000 on a table or
shelf
You can install a single VSP 4000 switch on any flat surface. The surface must support the
combined weight of the switch and attached cables (from 15 and 20 pounds [7 to 9 kilograms]).
To install an VSP 4000 on a table or shelf, perform this procedure.
Caution:
Do not place an Extreme NetworksEthernet Power Supply Unit or Ethernet Redundant Power
Supply on top of an VSP 4000. The switch housing of an VSP 4000 cannot support the weight
of these units. For a translation of this statement, see
page 43.
1. Remove the screws that hold the USB cover but do not remove the USB cover.
Caution:
To ensure proper operation, the USB FLASH drive must remain inserted in all models of VSP
4850 (factory built and converted from ERS 4850), with the cover installed for additional
protection against removal. The USB FLASH drive on the VSP 4850 switch is uniquely bound
to the system it was first used on and cannot be transferred to a different switch.
2. Attach the included rubber footpads on the bottom of the switch at the locations indicated.
August 2018

Installing the Virtual Services Platform 4000 on a table or shelf

Power cord types and order codes
Installing Virtual Services Platform 4850GTS Series
on page 11.
Translations of safety messages on
23