Port Leds In Stk Mode; Versatile Interface Modules (Vim) Port Leds - Extreme Networks ExtremeSwitching 5520 Series Hardware Installation Manual

Port LEDs in STK Mode

1x40 mode, the first LED will indicate the port state and traffic and the second LED will be offColor and
blink pattern indicate speeds, as referenced by the following table:
Table 29: Port LEDs in SPD Mode
Color/State
Slow blinking green
Fast blinking green
Steady green
Slow blinking amber
Fast blinking amber
Slow blinking green
Fast blinking green
Fast blinking green
Fast blinking green
Port LEDs in STK Mode
After two presses of the Mode button, the port LEDs will enter the STK Display Mode, indicated by the
STK LED. STK mode is used to indicate slot presence and slot number via the first eight port LED, as
referenced by the following table:
Table 30: Port LEDs in STK Mode
Color/State
Steady green
Blinking green
Table 31: Management Port LEDs
Right side LED
Link
Left side LED
Act

Versatile Interface Modules (VIM) Port LEDs

There are two supported modes for ExtremeSwitching 5520-VIM port LEDs:
•
SYS - default, use normal port LED behavior for link, traffic, and PoE
•
SPD – use the port LEDs to indicate operational speed
126 ExtremeSwitching 5520 Series Hardware Installation Guide
Speed
Slot corresponding to the port number of the LED is present
This slot has slot number corresponding to the port number of the blinking LED
Solid Green
Off
Blinking Green
Off
State
Link up
No link up or port disable
State
Packet transmitting or receiving
No packet transmitting or receiving
Monitoring the Device
Speed
10Mbps
100Mbps
1000Mbps
2.5Gbps
5Gbps
10Gbps
25Gbps
40Gbps
50Gbps