Install A V300 Virtual Port Extender On A Wall - Extreme Networks ExtremeSwitching 5520 Series Hardware Installation Manual

Install a V300 Virtual Port Extender on a Wall

5. When power is connected, verify that the SYS LED on the port extender turns green.
If the SYS LED does not turn green, verify that the power source is on and the connection was made
properly.
6. Optionally, connect the port extender to a redundant power source, depending on the model.
The following mounting kits are available for non-PoE V300 models:
Table 26: V300 Mounting Kits
Kit part number
XN-2P-RMTKIT-1CS-001
XN-2P-RMTKIT-2CS-001
XN-DIN-MT-001
XN-MTKIT-CS-001
XN-PS-MT-001
For additional installation options, including non-PoE V300 Mounting Kit installation, see the following
topics:
•
Install a V300 Virtual Port Extender on a Wall
•
Install a V300 Virtual Port Extender Under or on a Table Surface
•
Install a V300 Virtual Port Extender in a VESA Mount
•
Install a V300 in a Single Rack Mount
•
Install a V300 in a Dual Rack Mount
•
Install a V300 in a DIN Rail Mount
•
Install a V300-8P-2T-W Model in a Single or Dual Rack Mount
•
Installing a V300-8P-2T-W Model in a DIN Rail Mount
Install a V300 Virtual Port Extender on a Wall
The following tools and materials are required to install a V300 Virtual Port Extender to a wall:
•
ESD-preventive wrist strap
•
M3.5 #2 Phillips screwdriver (magnetic screwdriver recommended)
•
M4 #2 Phillips screwdriver (magnetic srewdriver recommended) for non-PoE models
Note
The mounting surface, item, and hardware must be able to support the extender in all
environmental conditions. The mounting surface must also be flat.
Typical installation for the V300-8P-2T-W model include wall or table installations, in addition to VESA
mounting.
There are several orientations for installation on a wall. To install the V300-8P-2T-W model on a wall:
1. Attach the short brackets to both sides of the extender
The orientation for wall mounting should be front panel facing down.
88 ExtremeSwitching 5520 Series Hardware Installation Guide
Description
Single rack mount kit
Dual rack mount kit
DIN Rail mount kit
Replacement surface mount kit
PSU mount kit
on page 88
on page 93
on page 95
on page 98
on page 101
on page 105
Installing Expansion Modules
on page 91
on page 104