2000 W Ac Power Supply Technical Specifications; Power Cord Requirements For Ac-Powered Switches And Ac Power Supplies - Extreme Networks ExtremeSwitching 5520 Series Hardware Installation Manual

2000 W AC Power Supply Technical Specifications

2000 W AC Power Supply Technical Specifications
The 2000 W AC power supply with front-to-back airflow (part no. XN-ACPWR-200W-F) is available for
use in 5520-24W, 5520-12MW-36W, and 5520-48W model switches:
Table 82: Physical Specifications
Dimensions (with handle)
Dimensions (without handle)
Weight
Table 83: Power Specifications
Voltage input range
Nominal input ratings
Maximum inrush current
Output
Power supply input socket and cord
Power cord wall plug
Efficiency
Table 84: Environmental Specifications
Operating temperature
Storage temperature
Operating humidity
Operational shock
Power Cord Requirements for AC-Powered Switches and AC Power
Supplies
An AC power cord is not included with the AC power supply.
Power cords used with AC-powered switches or AC power supplies must meet the following
requirements:
•
The power cord must be agency-certified for the country of use.
•
The power cord must have an IEC320-C13 connector for connection to the switch or power supply.
146 ExtremeSwitching 5520 Series Hardware Installation Guide
Height: 1.57 inches (4 cm)
Width: 3.25 inches (8.25 cm)
Length: 11.51 inches (29.25 cm)
Height: 1.57 inches (4 cm)
Width: 3.25 inches (8.25 cm)
Length: 10.25 inches (26.05 cm)
2.95 lb (1.34 kg)
100-200 50 to 60Hz
12.5 A max at 115VAC and 6A max at 230VAC at Full 770 W load
45A at Max 264 VAC at 25C with cold start
54 V, 13.2 A max, 2000 W
IEC/EN 60320-1/C16 AC input receptacles
Refer to Power Cord Requirements for AC-Powered Switches
and AC Power Supplies on page 146
Minimum efficiency: 88% at maximum power output
0°C to 50°C (normal operation)
-40°C to 70°C
93% relative humidity, non-condensing at 30C
Technical Specifications