Threading Preparations / Tips - JUKI MO-735N Instruction Manual

Threading preparations / tips

Switch the machine off (power switch "O")
• Support rod with thread guide must be fully raised.
• Open the looper cover.
• Turn the handwheel towards you until the needles are fully raised.
Match the matching up marks on handwheel and side cover.
• Raise the upper knife.
• Raise the presser foot. The tension is automatically released.
Thread the machine carefully and in the correct sequence.
Invaluable threading aids simplify threading:
• Colored threading illustration.
• Color coded thread path on the machine.
• Threading accessories.
Re-threading or changing threads
If spools are empty or you want to change the thread, it is not necessary to rethread the machine. Simply cut off the
threads above the cones or spools, replace them and knot new thread on to the existing thread. Cut the threads off at
the needles. Raise the presser foot, pull the threads through and rethread the needles. Pull the looper threads through
using the existing thread chain. Some thick decorative threads cannot be pulled through the looper eyes. Lower the
presser foot. Select the stitch of your choice and test sew.
19
First thread guide on the machine (lay-in threading)
The thread guides on the top of the machine are color coded and simple to
thread.
Hold the thread with both hands and slip into the appropriate guide from back
to front in the direction of the arrow and pull gently.
Needle-/looper threader
Insert thread into threader. Push the rigid end of the threader from front to the
back through the looper or needle eye and pull completely through the eye.