Threading, Chain Stitch And Ol - JUKI MO-735N Instruction Manual

Threading, Chain stitch and OL

26
1. Threading chain stitch looper (purple)
Place the spool on the spool holder pin as illustrated.
(1,2) Bring the thread up from the spool and lay it from the front to the
back into the guide.
(3,4) Thread the guides.
(5) Thread the tension dial.
(6,7,8) Thread the guides.
(9) Place the thread horizontally in the guide.
(10,11) Thread the guides.
Bring the needles into the lowest position. Turn handwheel.
(12) Push the chain looper auto-threader (white) up towards the chain
looper and press them down together.
(13) Thread the looper thread guide back to front.
(14) Thread the looper eye front to back and cut thread to about 10cm
(4").
(15) Push the chain looper back up to sewing position.
Raise the needle to highest position (turn handwheel).
Note:
If the chain looper has to be re-threaded, cut the needle thread above
the needle eye and remove. Thread the looper first and then the nee-
dle.