Threading 4 thread cover stitch
34
1. Threading cover stitch looper (purple)
Place the spool on the spool holder pin as illustrated.
(1,2) Bring the thread up from the spool and lay it from the back to the
front into the guide.
(3,4) Thread the guides.
(5) Thread the tension dial.
(6,7,8) Thread the guides.
(9) Place the thread horizontally in the guide.
(10) Thread the guide.
Bring the needles into the lowest position. Turn handwheel.
(11) Do not use this guide. (for chain stitch only)
(12) Push the looper auto-threader (white) up towards the chain loop-
er and press them down together.
(13) Thread the looper thread guide back to front.
(14) Thread the looper eye front to back and cut thread to about 10cm
(4").
(15) Push the looper back up to sewing position.
Raise the needle to highest position (turn handwheel)
Note:
If the looper has to be re-threaded, cut the needle threads above the
needle eye and remove. Thread the looper first and then the needles.