Table of Contents
Advertisement
Threading, Chain stitch and OL
1
2
5
6
9
2
3
4
7
8
6
7
8
9
2. Chain-needle, brown markings (use yellow
tension)
Place the spool on the spool holder pin as illustrated.
(1) Bring the thread up from the spool and lay it from the back
to the front into the guide.
(2) Thread the first machine guide.
(3) Slip the thread through the groove.
(4,5) Take the thread under the thread guide plate and through
the take up.
(6) Thread the guide.
(7,8) Thread the guide on the needle clamp.
(9) Thread the chain needle from front to back.
Place the thread underneath the presser foot.
Lower presser foot.
When threading is complete, lower the upper knife and close
the looper- and the cloth plate cover.
Note:
If the looper has to be re-threaded, cut the needle thread off at
the needle and remove surplus thread from below. Thread the
looper and then re-thread the needle.
27
Advertisement
Table of Contents
