Table of Contents
Advertisement
Appendix A
70
Table A-1. Error Messages and Explanations
This operation might cause
an OSPF Database Reset.
Press 'Yes' to continue.
Press 'No' to discard your
changes. Press 'Cancel' to
cancel the operation.
Some mandatory
parameters were not
entered.
Please enter a valid Net
Number.
The Redundancy TimeOut
must be at least twice
bigger than Redundancy
Polling Interval.
Set is not allowed for
'inactive' and 'active'.
Since the Source Mask is X.
The Source Address should
be X.
Main Router Address must
be on the same IP subnet
as the interface X.
Please enter any Hex
number between X and X.
Please enter a valid Hex
number.
The interface you are
trying to delete has an IP or
IPX interface bound to it.
You must delete that
interface first.
Bad IfIndex or IfName.
Invalid IP address, Netmask
or illegal IP/Mask
combination.
Displayed when the user changes the OSPF
global status to disable, or changes the OSPF
Router ID.
Displayed to notify the user that required fields
for this window have not been filled. The cursor
is usually positioned at the next required field.
Displayed when an invalid net number is
entered in a field that expects a net number.
This message only appears when the Enter
button is pressed.
Displayed when a redundancy time-out is
selected in the IP Redundancy window that is
less than twice the Redundancy polling interval.
Displayed to indicate that the 'inactive' and
'active' options are unavailable.
Displayed when there is an inconsistency
between the Source Mask and the Source
Address entered.
Displayed when there is an inconsistency
between the IP address and the Main Router
address on the same subnet X.
Displayed when an out of bound hex number is
entered for a field that should contain a value in
the range X to X.
Displayed when an invalid entry is entered in a
field that expects a hex number. This message
only appears when the Enter button is pressed.
Displayed when a layer 2 interface is being
deleted. The device will not delete an interface
that has an IP or IPX interface.
Displayed when creating a new layer 2
interface, if the IfIndex or the IfName are
invalid. This could be caused by a duplicate
index or name, or an index that is too big.
Displayed when an error occurs while creating
an IP interface.
Avaya M-MLS Routing Manager User Guide
Advertisement
Table of Contents
