Display Feature Procedures; Call Information; Exit (Normal) - Lucent Technologies Definity 8434DX User Manual

Display Feature Procedures

This section includes the procedures for seven display features you may use with the
8434DX voice terminal. However, note that the display, along with the softkeys and
display control buttons, can also be used for accessing up to 15 softkey features. For
procedures on using the display and softkeys and a list of the features that can be
accessed with the softkeys, see "Using the Display, Softkeys, and Display Control
Buttons" earlier in this guide.

Call Information

You may have as many as 34 call appearance buttons. The two columns of buttons on
the left (five buttons in each column) are labeled a through e and f through j. (The
24 buttons on the right are NOT labeled.) When the display shows
represents call information for the first call appearance button. The next button
down would be shown as
of the buttons are used for call appearances.
When you dial an extension, that number is shown then replaced by the called
party's name and extension.
When a call is received from another extension, the caller's name is shown; when a
call is received from outside, "OUTSIDE CALL" or a trunk identifier is shown.
The display remains in Normal Mode until you activate one of the other display or
softkey features. After using any of these features, return to Normal Mode by
pressing Exit
.

Exit (Normal)

To return to normal
display after using any
display feature
, and so on, continuing through
b=
1
Press
Exit
Display will show call information for the active
call appearance
it
a=
if all 10
j=
39