Invacare TDX SP User Manual page 78

Invacare® TDX® SP
SYMPTOM PROBABLE
CTRL NOT The CMPJ or
CONNECTED Display module is
not communicating
with the control
module (Error code
E200).
CTRL COM FAULT The controller has
displays and the determined a fault
wheelchair drives during a previous
slowly. turn-off process
(Error code E41).
MISSING One or more
CONFIGURATION devices have
displays at power been removed or
up. disconnected from
the wheelchair.
ATTENDANT The Proportional
ACTIVE and or Digital Attendant
displays. control is active and
can be used to drive
the chair.
78
CAUSE SOLUTIONS
Check the
connections
between the joystick
or display and the
controller. Turn the
power off and then
back on. Replace
the controller if
necessary.
Turn the wheelchair
off and back on.
Reconnect the
device.
This is normal
behavior.
SYMPTOM PROBABLE
CAUSE
Batteries draw Battery failure.
excessive current
Electrical
when charging.
malfunction.
Battery indicator
Battery failure.
flashes the charge
Malfunctioning
level is low -
battery charger.
immediately after
Electrical
recharge.
malfunction.
Battery indicator Batteries not
flashes the charge charged.
level is low - too
Weak batteries.
soon after being
recharged.
SOLUTIONS
Have batteries
checked for shorted
cell. Replace if
necessary.
Contact
Dealer/Invacare
for service.
Check batteries
for shorted cell.
Replace if necessary.
Contact
Dealer/Invacare
for Service.
Contact
Dealer/Invacare
for Service.
Have charger
checked.
Replace batteries
if necessary. Refer
to 8.12 Replacing
Batteries and/or
Battery Cables, page
67.
1143190-N-03