Specifications; Positioning The Wheelchair In The Vehicle; Securement Points - Invacare TDX SP User Manual

Hide thumbs Also See for TDX SP:
Table of Contents

Advertisement

Invacare® TDX® SP

7.5 Specifications

MODEL
MOTOR
TDX SP HD
TDX SP
4 Pole HD
TDX SR
TDX SR HD

7.6 Positioning the Wheelchair in the Vehicle

This wheelchair MUST be in a forward facing position during travel
in a motor vehicle.
The recommended clear zones for wheelchair seated occupants
restrained by both pelvic and upper torso belt(s) and only by a pelvic
belt are shown in the diagrams and described below.
Frontal Clear Zones (FCZ) need to be LARGER when upper torso
belt(s) are NOT used.
The rear clear zone of 16 inches (41 cm) is measured from the
rearmost point on an occupant's head.
The frontal clear zone is measured from the frontmost point on an
occupant's head and is 26 inches (66 cm) with pelvic and upper-torso
belt(s) and 37 inches (94 cm) with ONLY a pelvic belt.
The frontal clear zone may not be achievable for wheelchair-seated
drivers.
52
WEIGHT LIMIT
Adult
Junior
Up to 400 lbs
N/A
(181 kg)
Up to 300 lbs
Up to 150 lbs
(136 kg)
(68 kg)
Up to 300 lbs
Up to 150 lbs
(136 kg)
(68 kg)
Up to 400 lbs
N/A
(181 kg)
The estimated seated height (HHT) from the ground or floor to
the top of the wheelchair-seated occupant's head ranges from
approximately 47 inches (119 cm) for a small adult female to about
61 inches (155 cm) for a tall adult male

7.7 Securement Points

ITEM
A
DESCRIPTION
TIE DOWN BRACKETS
1143190-N-03

Advertisement

Table of Contents
loading

Table of Contents