Table of Contents
Advertisement
Framing Dimensions (Left Corner)
NOTE: Framing may be constructed of combustible material (ie. 51mm x 102mm) and does not require steel studs.
Framing
Description
Dimensions
A
Framing Height
B
Framing Width
C
Framing Depth
D
Unit Base to Top Enclosure (Min.)
G
Flue Centerline Height
NOTE: Unit cannot be load-bearing. All finishing materials must be supported by the framing.
Note: This appliance must be in-
stalled on a level and solid surface
such as a plywood floor which must
be the full width and depth of the
appliance.
ACC40LE
949mm
1226mm
483mm
1600mm
1429mm
Maximum material dimen-
sions 51mm x 102mm for
Header studs (installed
on edge and flat)
installation
Note: A combined minimum of
774 square centimetres of open
area is required for the convection
air outlet to cool the enclosure.
Ensure clearances for Convection
Air Outlets are met.
See clearances ACC40LE/AC-
C40RE (single sided) in this manual
as there are different methods as to
how this can be achieved.
City Series ACC40E |
27
Advertisement
Table of Contents
