Accessories And Documentation - VeriFone P200 Installation Manual

Accessories and
Documentation
Using the Phillips head screw driver, remove each of the eight screws. Four of
4
the screws (screw numbers 3, 4, 5, and 6) covered by the rear cable cover.
You must remove the cable cover to access these screws.
Screw #4 on the left is covered by a tamper-evident security label. Push the
screw driver through this label to access the screw.
#3
#2
Figure 19 P200 Bottom
Once all the identified screws have been removed, carefully separate the top
5
housing plastics from the bottom 1mm, then pinch the top and bottom housing
back together ensuring proper fit.
Reinsert all of the screws previously removed. Tighten each screw completely.
6
Insert the power cable and power up the device.
7
Turn the device face up showing the display and keypad. Verify that the unit is
8
in an "Active Tamper." You should see the *TAMPER* message displayed on
the screen.
Verifone produces accessories and documentation for the P200. When ordering,
please refer to the part number in the left column.
Verifone Online Store at
•
USA – Verifone Customer Development Center, 1-800-Verifone (837-4366)
•
Monday - Friday, 7 A.M. - 5 P.M., MST
International – Contact your Verifone representative
•
#6
#5
#4
#1
www.store.verifone.com
S
ERVICE AND

Accessories and Documentation

#7
#8
P200/P200 P I
LUS NSTALLATION
S
UPPORT
G
UIDE 33