S
ETUP
Optional Accessories
Performing
Contactless
Transactions
Optional
Accessories
Privacy Shield
Installing the Privacy
Shield
Stylus and Holder
Attaching the Stylus
Holder
Mounting Adapter
Attaching a Mounting
Adapter to P400
Mounting P400 with
Mounting Adapter to
a Wall or Flat Surface
18
P400/P400 PLUS I
NSTALLATION
To perform a contactless smart card transaction:
1
Gently tap the card onto or hold the card (within 4 cm) against the surface of
the display.
2
An activated LED visual on the display accompanied by a short beeping sound
indicates a successful transaction.
These accessories can be used to further enhance the device's functionality. See
Accessories and Documentation
The privacy shield is used to hide the keys when entering user password in a
transaction.
To install a privacy shield:
1
Align the hooks on the privacy shield with the corresponding slots beside the
keypad on the terminal.
2
Once the hooks are in place, gently push down on the privacy shield until it
snaps into place.
A stylus with holder can be attached to P400 and used as an alternative device
input method.
To attach the stylus:
1
Align the stylus holder's screw holes with those found on the back of
the terminal.
2
Screw the holder onto the back of the terminal as shown in the illustration
below:
This accessory is used to mount P400 to vertical or inclined surfaces.
To attach a mounting adapter to P400:
1
Align the screw holes at the back of the terminal with the corresponding
screws on the mounting adapter (this can be done with or without the stylus
holder attached).
2
Screw the mounting adapter in place while keeping the terminal aligned with
the mounting adapter.
To mount the terminal to a wall or flat surface:
1
Ensure the mounting adapter is attached to the terminal.
2
Attach three M3 screws (not included in P400 package) to the desired surface.
Make sure that they are aligned with the slots on top and at the bottom of the
mounting adapter.
G
UIDE
for additional information.