Rear Panel; Turning The Power On/Off - Roland VC-100UHD Startup Manual

Hide thumbs Also See for VC-100UHD:
Table of Contents

Advertisement

Rear Panel

19
9
10
Name
12
HDMI 4K OUT connector
13
12G-SDI THRU connector
14
12G-SDI IN connector
15
12G-SDI OUT connector
16
REFERENCE IN connector
REFERENCE THRU/OUT
17
connector
18
DC IN jack
19
Ground terminal
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.

Turning the Power On/Off

NOTE
This unit does not have a power switch.
We recommend that you use a commercially available power supply control device to control the AC power of this unit.
Turn on the power in the order of VC-100UHD 0 source devices 0 output devices.
When powering up
Turn off the power in the order of output devices 0 source devices 0 VC-100UHD.
When powering down
5
6
11
12
13
14
Explanation
This connector can output video up to 4K. Connect a video recording device or display here. Depending on
the setup settings, the signal of the HDMI 4K IN connector can be "thru-output" from here.
HDMI 2.0b 18 Gbps HDCP 2.2 is supported.
The video that is input from the 12G-SDI IN connector is output without change from this connector.
A re-clocker is built in.
This connector can input video up to 4K. Connect a video camera or similar device here.
Input up to 12G-SDI is supported.
This connector can output video up to 4K. Connect a video recording device or display here.
Output up to 12G-SDI is supported.
This connector inputs an analog external synchronization signal.
Black burst/2-value/3-value synchronization signals are supported.
When this unit is operating with internal synchronization, the internal synchronization signal of the unit is
output as black burst.
When this unit is operating with external synchronization, the external synchronization input is "thru-
output. "
Connect the included AC adaptor to this jack.
You can secure the plug of the AC adaptor by attaching the included DC plug stopper.
* The DC plug stopper can also be attached to the left side of the unit and used as a cable holder.
Attaching screw
DC plug stopper
Connect this to an external earth or ground. Connect this if necessary.
7
8
15
16
17
18
Panel Descriptions
Screw for
attaching DC plug stopper
DC plug stopper
Attaching screw
3

Advertisement

Table of Contents
loading

Table of Contents