Table of Contents
Advertisement
USING THE UNIT SAFELY
Secure a sufficient amount of space at the setup location
Since this unit normally emits a slight amount of heat, make sure to secure
sufficient space around it, as shown below.
Front
30 cm (12 in.) or
5 cm (2 in.) or
greater
greater
20 cm (8 in.) or greater
20 cm (8 in.) or greater
Use only the supplied AC adaptor and the correct voltage
Be sure to use only the AC adaptor supplied with the unit. Also, make sure the
line voltage at the installation matches the input voltage specified on the AC
adaptor's body. Other AC adaptors may use a different polarity, or be designed
for a different voltage, so their use could result in damage, malfunction, or
electric shock.
Use only the supplied power cord
Use only the attached power cord. Also, the supplied power cord must not be
used with any other device.
IMPORTANT NOTES
Power Supply
• Place the AC adaptor so the side with the indicator
faces upwards. The indicator will light when you plug
the AC adaptor into an AC outlet.
• Depending on the material and temperature of the
surface on which you place the unit, its rubber feet
may discolor or mar the surface.
Maintenance
• Before sending the unit away for repairs, be sure to
make a backup of the data stored within it; or you
may prefer to write down the needed information.
Although we will do our utmost to preserve the data
stored in your unit when we carry out repairs, in some
cases, such as when the memory section is physically
damaged, restoration of the stored content may be
impossible. Roland assumes no liability concerning
the restoration of any stored content that has been
lost.
8
WARNING
Side
15 cm (6 in.)
or greater
Additional Precautions
• Any data stored within the unit can be lost as the
result of equipment failure, incorrect operation, etc.
To protect yourself against the irretrievable loss of
data, try to make a habit of creating regular backups
of the data you've stored in the unit.
• Roland assumes no liability concerning the
restoration of any stored content that has been lost.
• Never strike or apply strong pressure to the display.
• When disposing of the packing carton or cushioning
material in which this unit was packed, you must
observe the waste disposal regulations that apply to
your locality.
• This unit allows you to switch images at high speed.
For some people, viewing such images can cause
headache, nausea, or other discomfort. Do not use
this unit to create video that might cause these types
of health problems. Roland Corporation will accept no
responsibility for any such health problems that may
occur in yourself or in viewers.
• Do not use connection cables that contain a built-in
resistor.
• This document explains the specifications of the
product at the time that the document was issued.
For the latest information, refer to the Roland website.
Using External Memories
• Please observe the following precautions when
handling external memory devices. Also, make sure
to carefully observe all the precautions that were
supplied with the external memory device.
– Do not remove the device while reading/writing is
in progress.
– To prevent damage from static electricity,
discharge all static electricity from your person
before handling the device.
Keep small items out of the reach of children
To prevent accidental ingestion of the parts listed below, always keep them out
of the reach of small children.
• Removable Parts
Screw for attaching DC plug stopper
Screws for attaching rack-mount angles
• Included Parts
DC plug stopper, Rubber feet
Handle the ground terminal carefully
If you remove the screw from the ground terminal, be sure to replace it;
don't leave it lying around where it could accidentally be swallowed by small
children. When refastening the screw, make that it is firmly fastened, so it won't
come loose.
Take care not to get burned
The top panel and bottom panel may become hot, so take care to avoid burns.
Intellectual Property Right
• It is forbidden by law to make an audio recording,
video recording, copy or revision of a third party's
copyrighted work (musical work, video work,
broadcast, live performance, or other work), whether
in whole or in part, and distribute, sell, lease, perform
or broadcast it without the permission of the
copyright owner.
• Do not use this product for purposes that could
infringe on a copyright held by a third party. We
assume no responsibility whatsoever with regard to
any infringements of third-party copyrights arising
through your use of this product.
• This product can be used to record or duplicate audio
or visual material without being limited by certain
technological copy-protection measures. This is due
to the fact that this product is intended to be used
for the purpose of producing original music or video
material, and is therefore designed so that material
that does not infringe copyrights belonging to
others (for example, your own original works) can be
recorded or duplicated freely.
• This product contains eParts integrated software
platform of eSOL Co.,Ltd. eParts is a trademark of
eSOL Co., Ltd. in Japan.
• This Product uses the Source Code of μT-Kernel under
T-License 2.0 granted by the T-Engine Forum (www.
tron.org).
• This product uses Free RTOS (MIT open source license)
and IwIP (BSD-style license).
• Roland is an either registered trademark or trademark
of Roland Corporation in the United States and/or
other countries.
• Company names and product names appearing
in this document are registered trademarks or
trademarks of their respective owners.
CAUTION
Advertisement
Table of Contents
