Table of Contents
Advertisement
Rear Panel
19
9
Name
5
AUDIO IN/OUT connector
6
LINE IN jacks (L, R)
7
LINE OUT jacks (L, R)
8
REMOTE connector
9
USB HOST port
10
STREAMING port
11
HDMI 4K IN connector
12
HDMI 4K OUT connector
13
12G-SDI THRU connector
14
12G-SDI IN connector
15
12G-SDI OUT connector
16
REFERENCE IN connector
REFERENCE THRU/OUT
17
connector
18
DC IN jack
19
Ground terminal
5
6
10
11
12
13
Explanation
This connector provides analog audio signal input/output (two balanced
inputs and two balanced outputs).
The output signal is the same as the output signal of the LINE OUT jacks.
These jacks input audio. Connect them to an audio mixer, CD player, or other audio or video device.
CH 1 is L and CH 2 is R.
These jacks output audio. Connect them to an audio recorder, amp, or speaker.
CH 1 is L and CH 2 is R.
This allows you to remotely control this unit from a computer using terminal software.
A USB flash drive can be connected to this port. This is used when saving/loading settings for the unit or when
updating the system program.
* While the screen indicates "Processing, " never turn off the power or disconnect the USB flash drive.
This is a USB 3.0 B-type port for video/audio output.
When you connect it to a USB port of your computer, this device is recognized as a web camera.
This connector can input video up to 4K. Connect a video device or computer here.
HDMI 2.0b 18 Gbps HDCP 2.2 is supported.
This connector can output video up to 4K. Connect a video recording device or display here. Depending on the
setup settings, the signal of the HDMI 4K IN connector can be "thru-output" from here.
HDMI 2.0b 18 Gbps HDCP 2.2 is supported.
The video that is input from the 12G-SDI IN connector is output without change from this connector.
A re-clocker is built in.
This connector can input video up to 4K. Connect a video camera or similar device here.
Input up to 12G-SDI is supported.
This connector can output video up to 4K. Connect a video recording device or display here.
Output up to 12G-SDI is supported.
This connector inputs an analog external synchronization signal.
Black burst/2-value/3-value synchronization signals are supported.
When this unit is operating with internal synchronization, the internal synchronization signal of the unit is output as
black burst.
When this unit is operating with external synchronization, the external synchronization input is "thru-output. "
Connect the included AC adaptor to this jack.
You can secure the plug of the AC adaptor by attaching the included DC plug stopper.
* The DC plug stopper can also be attached to the left side of the unit and used as a cable holder.
Attaching screw
DC plug stopper
Connect this to an external earth or ground. Connect this if necessary.
7
8
14
15
16
17
18
Panel Descriptions
Screw for
attaching DC plug stopper
ANALOG OUT
ANALOG IN
H
H
H
H
C
C
C
C
G
G
G
G
CH 2 (R)
CH 1 (L)
CH 4 (R)
CH 3 (L)
DC plug stopper
Attaching screw
3
Advertisement
Table of Contents
