Step 11 Install Floppy Drive - American Megatrends Super Voyager VLB-III User Manual

Step 11 Install Floppy Drive

J8 Floppy Disk Drive Connector
J8 is a 34-pin dual-inline berg. Connect the cable from the floppy drive to J8, as shown below. The onboard
floppy controller cannot be used if a hard disk adapter card with floppy controller is installed.
The motherboard supports up to two 720 KB, 1.44 MB, or 2.88 MB 3½" drives and 360 KB and 1.2 MB
5¼" drives. The connecting cable is a 34-pin ribbon connector with two 34-pin edge connectors for
attaching the floppy disk drives. There is a small twist in the cable between the floppy connectors. The last
(end) connector should be connected to floppy drive A: as shown below.
Chapter 2 Installation
76