Step 3 Install Memory - American Megatrends Titan III User Manual

Step 3 Install Memory

System Memory Four 32-bit SIMM (Single-Inline Memory Module) sockets can be used.
Memory must be populated one bank at a time. Each bank has two sockets:
(Bank0 is U16 and U12. Bank1 is U10 and U6). Each bank must be populated
with the same type of SIMM. If a 1 MB SIMM is installed in the first socket
in Bank0, the same type of 1 MB SIMM must be installed in the second
Bank0 SIMM socket. Each socket holds one SIMM. Use:
512 KB x 32 (or 36),
1 MB x 32 (or 36),
2 MB x 32 (or 36),
4 MB x 32 (or 36),
8 MB x 32 (or 36), or
16 MB x 32 (or 36) SIMMs consisting of 16 MB x 4 chips. Do not use 64 MB
SIMMs that have 36 chips.
The motherboard supports banks of fast page mode and EDO (Extended Data
Out) memory together operating at 60 ns (RAS access time).
You must use x 36 SIMMs when the Parity or ECC
WINBIOS Setup options are set to Enabled.
Memory Display System memory is reported by AMIBIOS as it boots and again when the
AMIBIOS System Configuration Screen is displayed just before the operating
system boots. The memory displayed by AMIBIOS on the System
Configuration Screen is 384 KB less than the total memory installed.
10 Titan III PCI EISA Motherboard User's Guide
Important
Cont'd