Table of Contents
Advertisement
Step 6 Connect the Power Supply
The power supply should match the physical configuration of the chassis. Make sure that the power switch
is Off before assembly.
Before attaching all components, make sure that the proper voltage has been selected. Power supplies often
can run on a wide range of voltages and must be set (usually via a switch) to the proper range. Use at least a
230 watt power supply, which should have built-in filters to suppress radiated emissions.
Connect to P1 and P2
Attach the power supply cables to P1 and P2 on the motherboard. AT-compatible power supplies have two
6-pin connectors. The 6-pin connector with 3 red wires and 2 black wires is connected to P2 and the
remaining 6-pin connector is connected to P1, as shown below.
Power Supply Connectors
Super Voyager VLB-III ISA Motherboard User's Guide
59
Advertisement
Table of Contents
