Step 9 Install Floppy Drive - American Megatrends 42 Series User Manual

Step 9 Install Floppy Drive

P6 Floppy Disk Drive Connector
P6 is a 34-pin dual-inline berg. Connect the cable from the floppy drive to P6. The onboard floppy controller cannot be used if a
hard disk adapter card with floppy controller is installed. The following graphic depicts a floppy cable and the P6 34-pin floppy
connector.
The Mark V Baby Screamer supports 3½" and 5¼" floppy disk drive in low density (360 KB/720 KB) and high density (1.2
MB/1.44 MB). Up to two floppy disk drives can be connected to the interface. The connecting cable is a 34-pin ribbon
connector with two 34-pin edge connectors for connection to the floppy disk drives. There should be a small twist in the cable
between the floppy connectors, and the last (end) connector should be connected to the floppy drive that will be drive A.