FireplaceXtrordinair ProBuilder 72 MV Installation Manual page 18

18
4 Remove the (4) screws from each of the (2) header shields (keep the screws for reinstallation). Turn
each of the shields over endwise and secure them back into place using the screws you just removed.
The bent edge of the shields should be facing upward and toward the back of the fireplace (see
illustration below).
5 The (2) header standoffs are screwed down flat to front edge of the top of the shields. On each standoff,
remove the screw that is closest to the outside edge of the fireplace (keep screw for reinstallation). Bend
the legs at the perforations as shown below and attach the foot of the standoff to the top of the fireplace
using the screw removed earlier in this step.
© Travis Industries
Installation
(for qualified installers only)
4/22/21 - 1458 PB 72 MV/GSB2/GSR2 Install