Installation (When The Expansion Board/Connector Conversion Adapter Is Used Together) - Mitsubishi Electric MELSEQ FX3S Series User Manual

FX Series Programmable Controllers
3S
User's Manual - Hardware Edition
17.3.2 Installation
(when the expansion board/connector conversion adapter is used together)
Installation procedure
1
Attach the expansion board/connector conversion adapter to the main unit.
Caution
Make sure to attach the expansion board/connector conversion adapter before the memory cassette.
Tightening with tapping screws (M3×8) is not necessary.
2
Remove the upper connector cover (A in the
right figure).
3
Remove the part B shown in the right figure
using a nipper, etc.
Caution
Removal of the part B is not necessary when the connector
conversion adapter is used together.
4
Raise the memory cassette detachment lever
(C in the right figure).
5
Attach the memory cassette to the option
connector (D in the right figure) of the
expansion board or connector conversion
adapter.
→ For the attachment method, refer to Chapter 7.
A
C
5
D
17 Memory Cassette
17.3 Installation
2
B
4
179
11
12
13
14
15
16
17
A
B
C