American Dynamics SpeedDome Ultra VII EIS Installation And Service Manual page 5

Outdoor Mounting (Optional)
Note: This document does not include outdoor
installation and service instructions. For these
instructions, see RHODUL Outdoor Housing Install
Guide 8200-0492-01.
The camera dome attaches to outdoor walls and
ceilings using an RHODUL outdoor housing
(Figure 5) and an ROENDC end cap connected to
one of the following optional mounting structures
(Figure 7)
• RHOTR Over Roof Mount
• RHOTRF Over Roof Floor Mount
• RHOPN Pendant Mount
• RHOWPA Pole Mount
• RHOSW/RHOLW Wall Mount
• RHOWCA Corner Bracket.
The outdoor housing contains a pre-installed
mounting base, a cooling fan for hot weather, a
heater for cool weather and to prevent icing, and
surge protection circuitry.
An environmental PC board is used to pre-wire
cables. A round spring-finger connector on the
board makes electrical contact with the housing
and eyeball assembly as it connects to the base.
Note: Do not use the I/O board (designed for
indoor use) in place of the environmental board.
Figure 5. RHODUL outdoor housing (optional)
SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME
INSTALLATION AND SERVICE GUIDE
SpeedDome Housing Adapter
Bracket (Optional)
An RHSDA adapter bracket (Figure 6) enables the
dome to fit into SpeedDome indoor housings
(RD500A). Locking pins in the bracket enable the
dome to swing out for servicing or removal.
Figure 6. RHSDA adapter bracket (to used with
the RD500A housing)
5 of 37
8200-0184-14, REV. A