Disassembling The Dome - American Dynamics SpeedDome Ultra VII EIS Installation And Service Manual

Disassembling the Dome

CAUTION: Once disassembled, parts of dome
housing and eyeball assembly are "extremely
fragile" and may break. Use extreme care!
This section explains how to remove the following
parts from the camera dome.
• CPU board, page 26
• Power supply, page 26
• Pan motor, page 27
• Slot covers, page 27
• Camera, page 28
• Eyeball, page 29
• Camera/Lens board, page 29
• Tilt motor, page 30.
This section also explains how to update and
reprogram dome software (page 31).
To order parts (authorized users only),
see page 32.
Tools Required
• Phillips-head screwdriver.
• Small slotted screwdriver.
SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME
INSTALLATION AND SERVICE GUIDE
Removing the CPU Board
CAUTION: Electrostatic-sensitive device. Use a
ground strap when handling CPU board.
Referring to Figure 24.
1. Remove cap.
Remove three Phillips-head screws holding cap,
then "gently" lift cap to one side.
2. Detach connectors.
On CPU board, detach 8-pin power supply
cable from connector P1, pan motor cable from
connector P8, and 14-pin slip ring cable from
connector P2.
3. Remove CPU board.
Push your finger through large finger connector
hole in cap to pop out CPU board.
4. Reverse steps to reassemble.
CAUTION: Do not to pinch wires! When
inserting CPU board into housing, avoid
pinching power supply cable wires against
standoffs.
Figure 24. Removing the CPU board
P2
P8
P1
Metal fingers of
ribbon cable must
face contacts of
connector.
26 of 37
8200-0184-14, REV. A